10 exam-style questions with answers and explanations, straight from our 1,030-question bank. Tap an answer to check yourself. When you're ready, take the scored version in the free practice test.
The F1 exam has 65 questions and runs 1 hours 30 minutes.
These 10 free F1 questions are organized by exam domain, so you can see how each part of the Alternate Fuels Certification - F1 Compressed Natural Gas Vehicle blueprint is tested. Reveal the answer and explanation under each question.
Domain 1: Pre-Service Vehicle Inspection 9% of exam
Question 1
A fleet van arrives with a cracked cylinder shield. After approved shield removal, a qualified inspection finds the cylinder and mountings undamaged, within service life, and acceptable under the manufacturer's criteria. The vent and pressure-relief assemblies are intact. What belongs on the repair estimate?
Show answer & explanation
Correct answer: D - Replace the damaged shield with the specified part; retain the accepted cylinder.
Domain 2: CNG System Equipment Inspection 15% of exam
Question 2
Since a coolant-hose replacement, a dedicated CNG transit bus has developed regulator icing on sustained pulls. The engine reaches normal operating temperature, but the regulator stays cold. Inspection reveals that a regulator coolant hose is folded sharply against a bracket. Gas-leak testing finds no external leakage. What repair addresses the observed defect?
Show answer & explanation
Correct answer: A - Correct the hose routing and restore regulator coolant circulation.
Question 3
After CNG fueling, the nozzle is depressurized and disconnected normally. Once the brief connection release has dissipated, gas continues to escape from the vehicle's fill receptacle. Which component is intended to prevent this reverse flow?
Show answer & explanation
Correct answer: D - The fill-receptacle check valve
Question 4
Following body repair on a CNG minibus, fuel connections pass the prescribed leak test. The cylinder-valve enclosure remains sealed toward the passenger compartment, but its exterior vent hose is crushed behind a trim panel. The PRD has a separate, unobstructed discharge tube. How should the vent defect be corrected?
Show answer & explanation
Correct answer: B - Restore the enclosure's separate vent to the approved exterior route.
Domain 3: Leak Testing and Repairs 11% of exam
Question 5
An occupied CNG service bay's calibrated methane monitor reads 30% LEL, while its oxygen channel reads 20.6%. The shop's written gas-alarm action level is 20% LEL. Use a methane lower explosive limit of 5% by volume. Which concentration and immediate response should the technician report?
Show answer & explanation
Correct answer: A - 1.5% methane; evacuate the bay and activate the gas-alarm response.
Domain 4: Emissions and Performance Verification 20% of exam
Question 6
For an injected CNG engine, specified fuel-rail pressure is 400 kPa above intake-manifold pressure. Simultaneous measurements show 450 kPa absolute at the rail and 50 kPa absolute in the manifold at warm idle. Under the specified load, the readings are 490 and 90 kPa absolute, respectively. The technician expected rail pressure to stay at 450 kPa. How should these results be interpreted?
Show answer & explanation
Correct answer: A - Regulation is correct; the injector pressure differential is unchanged.
Domain 5: System Diagnosis, Maintenance, and Repair 29% of exam
Question 7
A bi-fuel pickup misfires on cylinder 2 during CNG acceleration but runs smoothly on gasoline. CNG rail pressure remains within specification during the misfire. Following the approved procedure, the technician interchanges the cylinder 2 and cylinder 5 coil-and-boot assemblies. The CNG misfire moves to cylinder 5. Which component is implicated by the interchange?
Show answer & explanation
Correct answer: C - The original cylinder 2 coil-and-boot assembly
Question 8
Warm, closed-loop operation of a bi-fuel van produces short-term fuel trim near +24% at idle on either fuel. At 2,500 rpm with no load, trim falls to about +3% on either fuel. No misfire is present, CNG pressure meets specification, and an upstream exhaust-leak check passes. Where should the technician concentrate the next leak check?
Show answer & explanation
Correct answer: C - The intake tract downstream of the airflow-metering point
Question 9
During a loaded test, a CNG truck loses power as regulator outlet pressure falls from 126 to 84 psig. Service information requires an outlet of 120-130 psig and at least 200 psig at the regulator inlet during this test. Simultaneous, verified readings show 2,600 psig at the cylinders but only 90 psig at the regulator inlet. Which diagnostic path should take priority?
Show answer & explanation
Correct answer: C - Localize a flow restriction between the cylinders and regulator inlet.
Domain 6: General Cylinder Safety and Maintenance 16% of exam
Question 10
A CNG delivery truck has a GVWR of 14,000 lb and an empty scale weight of 9,200 lb. Its cylinders were last inspected 14 months and 14,000 miles ago and remain within their marked service life. There has been no accident or fire, and no shorter manufacturer interval applies. Which disposition follows the routine inspection intervals specified by the FMVSS 304 cylinder label?
Show answer & explanation
Correct answer: B - Arrange the overdue annual inspection based on the truck's GVWR.
That's 10 of 1,030
The full bank has 1,020 more F1 questions with explanations.